arc_flywheel_2[1].jpg
Model 31 OHV avs

Model 31 avs ARC billet flywheel

345.00

ARC's SFI certified billet aluminum flywheel for the Briggs and Stratton vertical crankshaft Model 28-33 AVS OHV engine often used in lawnmower racing. The 6611 flywheels are designed as a bolt-on billet aluminum replacement for the cast-iron stock flywheel. The ring gear is a replaceable bolt-on piece, and is made of Steel making it considerably stronger than any other present alternative. (7075 billet aluminum ring gear is available if requested.) ARC flywheels have their signature steel adjustable timing hub which allows at-the-track timing changes at 1° increments in as little as 90 seconds without the use of offset keys or engine disassembly. The adjustable hub also makes it fast and easy to accurately set timing during engine assembly.

Other outstanding features include: • A 17% increase in voltage produced at the coil with a more accurate discharge of that current due to the aluminum body. • A 38% overall increase of voltage produced by the coil • Forward Curve fin design optimizes fan efficiency. • Neodymium (rare earth) magnet is the most powerful on the market. • The timing hub also functions as an ingenious flywheel remover.

 

This flywheel is designed to be used with the Hi-Torque Briggs Starter. This is the only starter you can use with the aluminum ring gear and our steel ring gear. 

This flywheel is designed with the intent of sanction racing only. This flywheel is not made to be used with stock charging systems.

Caution! Advancing the ignition timing to much may sound good at idle but will not always make more power. Too much timing will cause pre-ignition (Engine Knock or Rattle), over heating and exhaust valve flutter. Too much ignition has been the cause of many crankshaft failures. This is common on the single OHV engines like the Intek Engine, even using balanced billet crankshafts.

Quantity:
Add To Cart
arc_flywheel_2[1].jpg